STEN Mk İ Semi-auto Build Project

STEN Mk İ semi-auto 9mm carbine Build Project. \r
\r
This is a legal semi-auto build and an approved STEN design by the ATF. The STEN was built to comply with both Federal and State firearms laws.\r
\r
STEN Mk İ parts kit looks to have been built originally in the 1st half of 1944 according to the serial #. Its a Finnish Army model (stamped [SA]), which included a sling swivel under the receiver and on the stock.\r
\r
The reduced diameter STEN tube will not accept the original STEN FA Open Bolt. The unfinished STEN tube, semi-auto bolt, 16 barrel, a recoil assembly is from Indianapolis Ordnance.\r
\r
Most of the drilling and machining was done on an old 1hp Rockwell drill press. I purchased a cross slide table (X & Y axis) and a vise. Used some center point drill bits and a couple end mills. Dremel, angle die grinder, cut-off tool, aircraft rivet gun, hand files.\r
\r
Special features:\r
Removable barrel and front trunnion.\r
Lower receiver lug, allow the complete removal of the trigger group.\r
\r
Finish:\r
Parts blasted with aluminum oxide, then Parkerized with Manganese phosphate solution, and painted with Dupli-Color Engine Enamel semi-gloss black (#DE1635).