Protomaker 3D Printer Partly success at last

Protomaker 3D Printer Partly success at last

40x10 One wall calibration STL file link

https://github.com/ahmetcemturan/SFACT/blob/master/calibration/_40x10.STL

https://www.yobi3d.com/v/NGPIrK7r6u/_40x10.STL

https://forum.simplify3d.com/viewtopic.php?f=9&t=31

Using PLA, 1.75mm, Black

Temperature first layer 220° C other layers 200° C

First Layer height 175%, other layers 0.2mm

Heat bed turned off.

E3D-v6 HotEnd 0.4 nozzle. Semi automatic bed levelling/tramming as video shows.. Printing on to Blue Painters tape, lighty sanded and cleaned with isopropyl alcohol.

Display LCD 12864 full graphic smart controller and using RAMPS 1.4, Ardunio Mega, Marlin, Prontoface, Slic3r software

Two microswitches in series so if ether one is Triggerd, (open), it will get a signal

Not tested fully but it appears as if the Auto level height takes over some-how and can cause the side Z end stop to get knocked down. This is even though these two switches are connected in series, like one switch.

I play this music for some time, it is in the Start G-Code via Display LCD 12864 full graphic smart controller and using RAMPS 1.4 and Ardunio Mega Using G29 Auto level, tramming, routine

I get quite a bit of Ozze as it moves away, so I will try adjustment of the retaction later. ED3 V6 Hot End printing PLA

Protomaker Black Sprint Original 3D Printer advertised for spares or repairs.

It may take some time to get this 3D printer working to a level where it is usable due to lack of budget
Powder Coated Mild Steel Structure With Acrylic Build Platform
• Product Type : All In One Printers
• Cartridge Type : Original
• Utility : 3d Printing
• Printing Output : Colored
• Print Technology : Fused deposition modelling (FDM)
• Size : Large
• Other Features : Powder Coated Mild Steel Structure With Acrylic Build Plate

My Wordpress Blog will tell you more about:-

Protomaker Black Sprint Original 3D Printer

https://protomaker3dprinter.wordpress.com/

https://twitter.com/myvideostowatch
.