Network ip printer

Manual IP Setting through Control Panel

On the control panel, press OK.
Use the arrow buttons to select Network config., and then press OK.
Use the arrow buttons to select CFG TCP/IP, and then press OK.
Use the arrow buttons to select BOOTP, make sure the value is No, and then press OK.
Use the arrow buttons to select DHCP, make sure the value is No, and then press OK.
Use the arrow buttons to select IP BYTE 1, and then press OK.
Use the arrow buttons to change the value of IP BYTE 1, and then press OK.
Repeat steps 6 and 7 for IP BYTE 2, IP BYTE 3, and IP BYTE 4. Also, repeat steps 6 and 7 for the Subnet Mask (SM BYTE 1, SM BYTE 2, SM BYTE 3, SM BYTE 4 ) and Default Gateway (GW BYTE 1, GW BYTE 2, GW BYTE 3, GW BYTE 4).
NOTE: Example: If the IP address is 192.168.0.1
IP byte 1=192
byte 2=168
byte 3 =0
byte 4 =1
Use the Back or Cancel button to leave the Network config. menu.
Settings will take effect after Step 9 and the printer has returned to Ready.