LED Video lighting Using step down & boost up Voltage

LED Video lighting Using step down & boost up Voltage

I take Mains 240 Volts A.C. 50Hz into the Laptop Power Brick PA3201U-1AC which outputs 15 Volts DC, (i.e. step down), then I use the Boost converter to increase this 15 Volt voltage up to 30 Volts for two high power 30 Volts, 20 Watt LED's and a 30 Volt, 10 Watt flood light LED.

The 15 Volt supplies directly:-

Ring light LED's : Rows of 5 straw-hat LED's connected in parallel. Each one of the 5 LED's are at 3 Volts each=15 Volts from the power brick.
 
Ring light LED's : Rows of 5 straw-hat LED's connected in parallel.

Each one of the 5 LED's are at 3 Volts each=15 Volts from the power brick.
 
Number of Straw Hat LED's soldered in groups five LED, 5 LED's x 3 volts each powered directly off the computer power supply of 15 Volts. These groups of five LED's connected in parallel, to create more light, and hot glued to cut out cardboard as a ring light.

I sanded the tops of the Straw Hat LED's a bit to defuse the light a bit as well.

.