Iron man RING from a nut

in this project we build an iron man ring from a 60 mm stainless steel connection nut, although only 30mm was used and the final because thts's the size of the finger I wanted it for once the threds are removed with a carbide burr and a dremel. if you are new to working in metal stainless steel is quite hard, but brass would be a better choice if you can find it.
most of the geometry was cut with an angle grinder and thin cutting blade (I always wear a mask and full protective face guard). After filing in to shape, I used good quality 1mm drill bit for the eyes, then opened them out with a jewellwrs saw and small file.
I kind of liked the finish without the glowing eyes, but to get that effect i used 6mm isotopes which are used as fishinf lures,