How to Build Custom LED Strip Lighting

In this video my good friend Marco from @OVRLNDX joins me in the garage to show me how to build the custom LED light strips he has had in the rear of his Jeep for over 2 years. This setup consists of 3 connected LED flexible LED strips secured in an aluminum channel and uses a controller to allow dimming and wireless use. It is amazing just how simple and inexpensive this DIY project is and Marco shares a few soldering tips along the way.

Instagram:
@OVRLNDX
@TRAILRECON

Here is a list of the items that are similar to the ones in this video listed amazon (these are not the identical items). If you search around ebay, you may be able to save a few dollars:

Flexible LED strip: (Note: this one is different than the one used in the video)
Aluminum Channel:
LED Controller with Wireless Remote:
16 Gauge Wire:
Heat Shrink:
Wire Loom:
Soldering Iron:
Solder:
Flux:
3M Tape:


Disclaimer:
TrailRecon assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Due to factors beyond the control of TrailRecon, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not TrailRecon. This video is solely for entertainment purposes only.