Configuration Guide for Autonomous Aironet Access Points - CISCO AP 3502i Using CLI

Configuration Guide for Autonomous Aironet Access Points - CISCO AP 3502i Using CLI

Please Like & Follow My Channel

Configuration Steps

Step 1
Configure DHCP
ip dhcp pool NEWPOOL
network 10.10.8.0 255.255.255.0
default-router 10.10.8.1
dns-server 8.8.8.8
lease 0 0 59
-------------------------------------------------------------------------------------

Step 2
dot11 ssid (Name) Test
vlan (Number) 708
authentication open
authentication key-management wpa
guest-mode
infrastructure-ssid optional
wpa-psk ascii (Password) test123456+
-------------------------------------------------------------------------------------
dot11 guest

Step - 3
interface Dot11Radio0.80
encapsulation dot1Q 708 native
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding

------------------------------------------------------------------------------
Step - 4
interface Dot11Radio0
no ip address
encryption vlan 708 mode ciphers aes-ccm
ssid Test
antenna gain 0
speed basic-1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0 m0. m1. m2. m3. m4. m5. m6. m7. m8. m9. m10. m11. m12. m13. m14. m15.
station-role root
no dot11 extension aironet
l2-filter bridge-group-acl

Thank You